@brenno_athayde said in Client vpn não comunica com a filial:

Olá, consegui resolver o problema. Percebi que estava faltando adicionar o ip do meu túnel da VPN client-to-site no campo "IPv4 Remote network(s)" nas configurações de VPN Site-to-Site tanto na matriz, quanto na filial.
Agradeço muito pela ajuda @acamoura .

Olá @Brenno_Athayde,
Ainda bem que era um simples detalhe de somente ter que publicar a rede para que a comunicação fosse estabelecida e agora se encontra funcionando o tráfego normalmente.
Precisando estamos à disposição.

Thanks for the information!

Well, I have just got it working. The solution may be very specific to my scenario.

First, I need to go through and test all the individual changes I made to ensure each one was needed, remove the cruft that was not needed and I will post the final solution here there after.

What I had to do in this scenario was go Pfsense A, go to advance settings of IPsec, From there:

Auto-exclude LAN address Enable bypass for LAN interface IP Exclude traffic from LAN subnet to LAN IP address from IPsec.

This box was checked by default.

I cleared it and traffic is now working both ways.

I suspect what mattered here was the fact that Pfsense A didn't have a LAN subnet, and OpenVPN client subnet may have been seen as a LAN by this rule. I am sure one of the Pfsense developers could provide an explanation.

Now I just need to check all the routes, rules, Phase 2 parts to ensure they are needed.

@treborjm87

I'd be curious about this as well...

I think you need to establish how much throughput/bandwidth you need and how many concurrent user connections you anticipate, etc? (Is this box dedicated to routing and VPN only or more exotic use cases like running VMs, etc)

I've seen some charts floating around with hardware recommendations based on required throughput here and at the servethehome website.

https://www.netgate.com/docs/pfsense/virtualization/virtio-driver-support.html

СА на сервере -
0_1533291210606_Screenshot_3.png
ВПН сервера (с 1195 портом это тот который сейчас нормально работает на старом пфенсе а с 1190 тот который не могу завести
0_1533291294677_Screenshot_1.png
Клиент на новом пфенсе
0_1533291434217_Screenshot_2.png